December 19,am 0 marlin single nozzle Hello, I've seen someone post marlin as firmware for a scara arm robot.
I know how this works with a 3d print but I was curious if someone can point me to some resources that would help me modify the firmware so I could integrate robot arm specific commands. For example, open and close robot claw singles hof saale a servo, turn on or off a vacuum gripper.
Would I most likely be modifying current gcode commands or could I add new ones?
Diese lassen sich übrigens bequem per Exzenter-Sitz einstellen und halten den Drucker spielfrei.
I'm not looking for someone to give marlin single nozzle the answer simply for someone to point me in the right direction if this is possible since it seem like modify marlin might be easier than me trying to learn the robot operating system since it appear that it will take longer to learn.
Thanks in advance for any and all help. December 19,pm 0 0 I'm trying to get my first print to stick to my bed and I'm not having much luck I'm using Slic3r and have gone through the program and I believe everything is set accordingly for my CoreXY setup.
I'm attempting to print Hatchbox PLA at C on bluetape on an aluminum non-heated bed at the moment as I think is what is recommended. I've successfully set the extruder feed rate, hot end temperature and bed temperature for my machine.
From what I can see from the video I've attached it looks as though the extruder is not feeding enough material so that got me thinking about some additional setup questions for Slic3r. This is a portion of the gcode I was attempting to print, nothing more than a flat disk. Any help or assistance would be appreciated.
Hab n Spannungsteiler gebastelt damit ich ihn anschliessen kann. Mein problem ist nun wie stell ich den in Marlin ein? Die neue FW hat doch mehr Klassen als ich gewohnt bin und ich hab irgendwie den überblick verloren.
Mag mir dabei evtl jemand helfen. Kann auch die ino hochladen zum anschauen. I have so far tried: - Enabling SD card support in the configuration.
December 19,am 0 0 Buonasera, ero intenzionato a montare i driver tmc su una ramps 1.